|
|
注意:本帖含有图片和附件资料 登录 才可查看，没有帐号？
您需要 登录 才可以下载或查看，没有账号？立即注册
×
富士施乐大风神 4127,4112 黑白高速复印机英文维修手册
PDF,2191页，英文，1.3版本
Due to standardization of Controllers, some machines with different names have the common Controller installed. They also display the same Fault Code.
2.3 Controller FIP in this manual describes all the Faults FIPs for the machine-independent Controllers.
Therefore, some Fault FIPs are not displayed in some machines. In that case, they must be ignored.
Refer to the corrective actions for the displayed Fault to repair the trouble. The following shows the flow of actual use.
1. Refer to the FIP corresponding to the displayed 6-digit Fault Code.
2. Follow the instructions in the FIP and proceed with the corrective procedures.
3. When the following items are stated in the corrective procedures, perform the appropriate corrective action to repair the trouble. If the problem persists, obtain the logs and request Support G for support to repair the trouble.
• Refer to "OF-xx".
• Perform "NET System Failure Check".
• Obtain "LOG".
• Perform "Software Download".
Though the repair procedures for those are not stated in FIP, they are stated in a referenced section.
Refer to the referenced section to proceed with the procedures.
NOTE: Some codes in IOT Fault Code (024-xxx) are repeated in 2.2 IIT, IOT & Option FIP. In that case, refer to the procedures in both sections.
NOTE: In OF-xxx, the replacing parts "IISS PWB", "IOT PWB", and "ESS PWB" are used. However,they are also referred to as IIT/IPS PWB, MCU PWB, and Mother PWB respectively in some machines. The function names need to be replaced with machine-specific PWB to perform replacement
|
|
发表于 2020-4-1 13:20:19
